| MOTOR SERIES TYPES |
POWER OPTIONS (HP) |
MAX. SPEED AVAILABLE (RPM) |
MAX. TOOL CAPACITY |
SPECIAL FEATURES |
COLLET & COVERNUT |
HSK-C |
HYDRO-CLAMP |
QUICK CLAMPING SYSTEMS |
TECHNICAL SPECS |
| KN 20 |
0.5 to 1 |
30,000 |
1/2" |
|
Y |
N |
Y |
Y |
PDF |
| KRS 35 |
1 to 3 |
18,000* |
1/2" |
*Available in 24,000 RPM |
Y |
N |
N |
N |
PDF |
| KRS 50 |
4 to 6.5 |
18,000 |
5/8" |
|
Y |
Y |
N |
N |
PDF |
| KRSV 51 |
6.5 |
18,000 |
1" |
|
Y |
N |
Y |
Y |
PDF |
| KRS 60 |
9.0 |
18,000 |
3/4" |
|
Y |
Y |
N |
Y |
PDF |
| KRSV 61 |
9.0 |
18,000 |
1" |
|
Y |
N |
Y |
Y |
PDF |
| KN 50 |
4 to 6.5 |
18,000 |
5/8" |
HSK-C Optional |
Y |
O |
N |
N |
PDF |
| KN 60 |
9.0 |
18,000 |
5/8" |
SK-C Optional; |
Y |
O |
N |
N |
PDF |
| KNO 70 |
10 to 17 |
18,000 |
1" |
|
Y |
Y |
Y |
Y |
PDF |
| VS 50/60 |
2 to 7 |
24,000 |
1/2" |
|
Y |
N |
Y |
Y |
PDF |
Prints are shown with collet & tool holding. Please contact us for motor prints with alternate tool holding options.
| TOOL SYSTEMS: |
- Collet & covernut
- HSK-C (Standard and optional as indicated in chart)
- Hydro-damp chuck system (ETP HydroGrip) on selected models
- Quick clamping system
- Cylindrical shaft with or without key
- Cylindrical shaft with or without key and outside thread
- Cylindrical shaft with or without key and inside thread
- Saw blade flanges and nut available
- External or internal taper
|
| FREQUENCY: |
- 60 to 500 HZ (3,600 to 30,000 RPM)
- Electrical performance data (HP) are only valid for the stated constant frequency
|
| VOLTAGE: |
- 230/400V standard according to DIN/VDE regulations; however, other voltage options are available
- Insulation class F standard
- If using a static frequency converter, it is necessary to use line reactors or filters to smooth out the sine wave
|
| BEARINGS: |
- Lifetime lubricated, high precision bearings (where required)
- Drive end bearing is fixed and non-drive end bearing is self-aligning
- With heavy tooling, double bearing arragements are recommended for front bearing position to eliminate axial shaft play
|
| FEATURES: |
- TEFC motors are self-ventilated with a built in fan which works most effectively at the motor's maximum operating speed
- Labyrinth seals at both ends of the motor to protect against dust or particle penetration into the motor when under power
- Motors are balanced to a vibration speed of Veff = 1.8 mm/sec at zero load and rated operating speed
- Most motors are available according to NEMA or CSA standards (L.R. 16 865)
|
